Machinist (Grades 7 - 9) at General Dynamics Bath Iron Works Montrose, AL 36559
Machinist (Grades 7 - 9)Job DescriptionThe pay range for this position ranges from $23.
82/hr - $26.
28/hr.
This is an experienced position to work in the Machinist Trade.
Machinists primarily set-up and operate machine shop equipment including (but not limited to):
lathes, radial drills, grinders, presses, punch presses, cut-off saws, milling machines, HBM, VTL, rolls, sheers, brakes, and burning machines.
Applicants hired into this position shall generally be able to operate most equipment with minimal training based on prior experience, including CNC operated equipment.
Machinists may be assigned any of the M04 Trade tasks.
Required/Preferred Education/TrainingPreferred - High School Diploma or GED.
Required - Technical school or at least two years of training in CNC machine operation.
Required - Knowledge of G-code.
Required/Preferred ExperienceRequired - Minimum 3 years demonstrated experience in the Machinist Trade.
Required - Must be able to read blueprints.
Required - Must be able to demonstrate knowledge and use of G-code.
Required - Must be able to read measuring tools:
tape measure, inside and outside micrometers, Vernier or dial calipers, dial indicators, etc.
and perform simple math calculations.
Required - Must meet the requirements of the M04 physical task analysis.
This opportunity is located in Bath, Maine.
Relocation is provided to all candidates outside of 100 miles who relocate to the area.
.
Estimated Salary: $20 to $28 per hour based on qualifications.
82/hr - $26.
28/hr.
This is an experienced position to work in the Machinist Trade.
Machinists primarily set-up and operate machine shop equipment including (but not limited to):
lathes, radial drills, grinders, presses, punch presses, cut-off saws, milling machines, HBM, VTL, rolls, sheers, brakes, and burning machines.
Applicants hired into this position shall generally be able to operate most equipment with minimal training based on prior experience, including CNC operated equipment.
Machinists may be assigned any of the M04 Trade tasks.
Required/Preferred Education/TrainingPreferred - High School Diploma or GED.
Required - Technical school or at least two years of training in CNC machine operation.
Required - Knowledge of G-code.
Required/Preferred ExperienceRequired - Minimum 3 years demonstrated experience in the Machinist Trade.
Required - Must be able to read blueprints.
Required - Must be able to demonstrate knowledge and use of G-code.
Required - Must be able to read measuring tools:
tape measure, inside and outside micrometers, Vernier or dial calipers, dial indicators, etc.
and perform simple math calculations.
Required - Must meet the requirements of the M04 physical task analysis.
This opportunity is located in Bath, Maine.
Relocation is provided to all candidates outside of 100 miles who relocate to the area.
.
Estimated Salary: $20 to $28 per hour based on qualifications.
|
|
 | |
